MOTOR
- concentrated viscosity
Concentrated product for cleaning of the engine block and engine parts from oil stains, grease leaks, sticky dust and other road dirt. Recommended for cleaning of any types of surfaces from layered oil, atmospheric and ground contamination.
Does not cause harm to treated surfaces.
PROFESSIONAL LOW-ALKALINE DETERGENT (pH 11)
METHOD OF APPLICATION:
- For maximum effect the engine temperature shall be within the range of 40°C-50°C.
- Prepare the working solution in a clean container considering the following calculation:
– For the foam generator: 1/9
– For the foam kit: without dilution
- Apply foam evenly to the entire surface of the engine and engine compartment.
- Hold for 3-5 minutes, preventing foam from drying out.
- Remove the foam with a high-pressure jet of water at the distance of 10-15 cm.
- Dry the cleaned surface with a suede moisture absorbent or microfiber cloth; blow the electrical contacts with high-pressure air.
Purpose |
Liquid concentrated viscosity-optimized low-alkaline product for non-contact washing of all types of surfaces from layered oil, environmental and ground contamination. |
Areas of application |
Cleaning of engine compartments of cars and trucks. Recommended for professional use only. |
General guidelines and dosage. |
It is used by application of active foam or aerosol on the engine and engine compartment preheated to 40оС -50оС at ambient air temperatures from +10оС to +40оС with subsequent holding for 3-4 minutes and flushing with water with application of the pressure of up to 2 MPa. In case of application it is allowed to use foam generators, sprayers (domestic atomizers), water pressure regulators. Working concentrations for foam generators and sprayers 1/8 – 1/10, for undermouth parts 1/0.2-1/0.3 (or without dilution). In winter time, it is recommended to use higher concentrations, in summer time it is allowed to use lower concentrations. |
Composition |
Softened water, sodium phosphonates (P2O5 5-15%) and EDTA 5-15%, NAEI 15-30%, solvent, dye. |
Technical data |
Appearance, odor – translucent low viscosity blue-green liquid with a light alcoholic scent. Density -1,04-1,06 g/cm3 Storage at temperatures from -18оС to +40оС. Freezing temperature about -15оС. Prolonged storage at low temperatures can cause delamination of the product (restores properties after exposure to temperatures above +5оС, with subsequent mixing). Chemical character – non-ionic. Solubility in water – complete at any ratio. pH of 1% solution 11,2±0.2 Ability to biodegradation – more than 90%. |
Safety |
Avoid using of the product at temperatures below 0°C, getting the concentrate on the skin and contact of the working solution with mucous membranes. When using sprayers, use respiratory protection against alkaline aerosols (3M respirators). Do not allow getting into the stomach. Overexposure of the working solution and its drying on the surface of paints, aluminum and metallized parts, especially at temperatures above 25°C can lead to irreversible damage. |
The company was founded in 1996
tons of products are sold annually
We deliver goods to all regions of the Russian Federation, CIS, Europe and Turkey
More than 200 partners