HARD
- non-contact cleaning of all types of surfaces in cars and public transport means
Concentrated product for contact-free washing of cars, trucks and public transport means. Ideal for removal of dirt in hard, ferrous water and at low temperatures. Creates a persistent abundant foam which can be easily washed off the surface. Does not cause harm to treated surfaces.
PROFESSIONAL LOW-ALKALINE DETERGENT (pH 12)
METHOD OF APPLICATION:
- Prepare a working solution in a clean container at the following rate:
– foam generator – minimum 25 ml, maximum 40 ml of the concentrate per 1 liter of water;
– foam kit – minimum 150 ml, maximum 250 ml of the concentrate per 1 liter of water
(the given limits of dosage of the concentrate depend on the degree of contamination of a surface to be cleaned).
- Pour the prepared working solution into the sprayer or the foam kit.
- Process the entire surface evenly with a clean high-pressure water jet from the distance of 10-15 cm at the angle of 90°, moving from bottom to top.
- Apply the foam to the surface, moving from bottom to top in order to avoid stains.
- Keep it for 2-3 minutes not allowing it to dry.
- Remove the foam with a high pressure water jet applying reciprocating movements for the range of 10-15 cm moving upwards from the bottom.
- Thoroughly rub the entire surface with plenty of low-pressure water moving from top to bottom.
- Dry lacquered and glossy surfaces with a moisture-absorbent suede or microfiber cloth.
Purpose |
Liquid concentrated, viscosity-optimized, low-alkaline, liquid foam for contactless cleaning of all types of surfaces from atmospheric and ground contaminants in difficult, ferrous water conditions and at low temperatures. |
Application variants |
Cleaning of vehicles, trucks and public transport means. Recommended for domestic and professional use. |
General guidelines and dosage |
The product is used by applying active foam or aerosol on a vehicle at temperatures from +1°C to +40°C with subsequent soaking for 3-5 minutes and washing off with water using a water jet with the pressure of up to 2MPa. In case of application it is allowed to use foam generators, sprayers (domestic atomizers), water pressure regulators. Working concentrations for foam generators and sprays are 1/60-1/90, and 1/5-1/8 for mountings. In winter time conditions, it is recommended to use higher concentrations and it is allowed to apply minimum concentrations in summer time. Application of excessive concentrations and overdense foam may impair the effect of the solution. |
Composition |
Softened water, sodium phosphonates (P2O5 5-15%) and EDTA 5-15%, anionic surfactants 5-15%, NAEI 5-15%, carboxylates, silicates, dye. |
Technical data |
Appearance and odor – semi-transparent, medium viscous, light brown liquid without characteristic odor. Density: -1,15-1,17 g/cm3 Storage: from -18оС to +40оС. Freezing temperature about -12оС. Prolonged storage at low temperatures can cause delamination of the product (restores properties after exposure to temperatures above +5°C, with subsequent mixing). Chemical character – anionic. Solubility in water – complete at any ratio. рН 1% solution 11,6±0.2 Ability to biodegradation – more than 90%. |
Safety |
Avoid using of the product at temperatures below 0°C, getting the concentrate on the skin and contact of the working solution with mucous membranes. When using sprays, it is necessary to apply respiratory protection against alkaline aerosols (3M respirators). Do not allow getting into the stomach. Overexposure of the working solution and its drying on the surface of paints, aluminum and metallized parts, especially at temperatures above 25°C can lead to irreversible damage. |
The company was founded in 1996
tons of products are sold annually
We deliver goods to all regions of the Russian Federation, CIS, Europe and Turkey
More than 200 partners